 | COMMERCIAL ENGINE STANDARD PRACTICES MANUAL | Dated: 12/14/2017 |
| SPM 70-16-02 TEMPORARY MARKING | ||
| COMMERCIAL ENGINE STANDARD PRACTICES MANUAL | Dated: 12/14/2017 |
| SPM 70-16-02 TEMPORARY MARKING | ||
| TASK 70-16-02-350-017 |
| 1 . | General. |
| CAUTION: |
|
| A. | Temporary marking is used to identify and/or indicate condition, position, and/or status of engine parts being disassembled or processed. |
| B. | Temporary markings are normally removed prior to engine operation. The materials selected, however, should be chosen so that failure to remove the marking/label will not cause damage or failure of parts. |
| C. | Temporary marking can be accomplished in 2 ways. |
| (1) | Labels and markers of various materials can be attached to the part by means of wires, ties, adhesives, etc. |
| (2) | Ink mark can be made on the surface of the part. |
| 2 . | Equipment. |
| Subtask 70-16-02-350-171 |
| D. | Not applicable. |
| 3 . | Materials. |
| Subtask 70-16-02-350-172 |
| E. | The following materials are required for the application of this process: |
| (1) | Felt-tip pen |
| (2) | Quick-drying ink |
| (3) | Non-metallic pencils |
| (4) | Pressure sensitive adhesive labels |
| (5) | Cardboard labels (tags) |
| (6) | Metal labels (tags). |
| 4 . | Procedure. |
| Subtask 70-16-02-350-173 |
| CAUTION: |
|
| F. | Attach label or mark parts as required. |
| 5 . | Quality Assurance. |
| Subtask 70-16-02-350-174 |
| G. | Ensure that markings are legible and that labels are secure. Ensure that marking products have been tested. |
| 6 . | Temporary Marking Materials. |
| Subtask 70-16-02-350-175 |
| H. | All marking materials must pass suitability tests. (See TASK 70-16-80-700-009, suitability test of temporary marking products.) |